Croydex AD107041YW Guía de instalación descargar pdf

Please follow the fixing and care instructions to ensure your product is fitted safely and retains its high

quality finish.

This instruction leaflet applies to the following products:

AD107041 Wireline Shower Curtain Cable

Fixing Pack Contents

(A) Fixing screws x 2

(B) Wall plugs x 2

(D) Spare collets x 2

Tools Required

Drill; 8mm masonry drill bit (8mm ceramic drill bit optional); Cross-head screwdriver; Pencil; Spirit level;

Sharp Wire Cutters; Hex Head Key (Supplied)

KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN

Home Safety Advice

Always take care when using an electric drill, particularly in the bathroom. Always check for hidden

cables and pipework before drilling and take extreme care if there is any water in the working area.

It is advisable to use a residual current circuit breaker (RCCB).

Always wear suitable eye protection when drilling.

If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should be used. Always ensure

that the drill hole passes through the central tiled area rather than through the grouted area. To prevent

damage to the tile, mask the area around the hole with tape before drilling.

Note: The wall plugs supplied are for use on solid walls only. For cavity walls or plasterboard

use specialist fixings that are available from all good DIY stores.

Fixing Instructions

1. Select the desired position of the Wireline and mark the centres of the mounting holes using the

wall brackets as a template. Remember to allow for the drop of the curtain hooks and sufficient

curtain overlap into the bath or shower tray. (See fig 1). Check the bracket positions are level.

2. The Wireline is supplied as a 3m length and can be cut to the required size using a sharp pair of

pliers or cable cutters. Firstly measure the gap between the fixing surfaces then carefully cut the

wire 60mm shorter than the measured distance between the fixing surfaces (See fig 2). Ensure

the end of the wire is cut square and the cut edge is not frayed. Care should be taken when

cutting the cable and handling the cut end. Do not cut the cable if under tension.

3. Using an 8mm masonry drill, drill the holes in the marked positions to a depth of 40mm. If drilling

through tiles, please pre-drill using a ceramic drill bit.

4. Insert the wall plugs to the surface of the wall. If fitting to a tiled surface, the wall plugs should be

inserted below the surface of the tile to avoid cracking.

R&R 033 R01

1 2

Fixing Instructions 1
R&R 033 R01 2

Indice de contenidos

Pagina 1 - Fixing Instructions

Please follow the fixing and care instructions to ensure your product is fitted safely and retains its high quality finish. This instruction

Pagina 2 - R&R 033 R01

5. Screw the wall brackets to the wall. (See Fig.3) 6. Thread one end of the wire through the small hole at the domed end of the wall bracket cov

Comentarios a estos manuales

Sin comentarios

Croydex AD107041YW Guía de instalación

Busca en linea o descarga Guía de instalación para No Croydex AD107041YW. Croydex AD107041YW Installation Guide Manual de usuario

Indice de contenidos

Comentarios a estos manuales